Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm using the Cisco VPN client to connect to a 2821. When creating traffic between the remote cisco vpn client software and the Office network which is behind the 2821, NBAR classifies the IPSEC traffic as "Unknown".I'd like to use nbar+qos to priori...
I'm having two odd problems with a 2821 that is used as a firewall. I'll describe one of them.Every few days, I can not access a server on the internet at port 1055. Running a 'clear ip nat trans *' does not fix the issue. Strangely enough, after rel...
I'm trying to locate a problem where Cisco VPN Client (I'm using v4.6) disconnects from an ASA v7.0 in less than 10 minutes if there is no activity. It stays up fine if there is network activity. This is a new install and so far everyone experiences ...
Upgrading didn't help. The problem magically went away. I'm still not sure what changed. I narrowed it down to a handful of lines in the Cisco config, though none of them should have helped the issue from what I could tell.
As another poster suggested ... I made sure Stateful firewall on the VPN client software was unchecked and added " client-firewall none" under "group-policy remotevpn attributes" to the ASA. No change.I've been looking through google and the asa to f...
