Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is the error I get when I try and set the 8.02 image as the boot image. Any suggestions?[OK] asdm image disk0:/asdm-602.bin[ERROR] boot config disk0:/asa802-k8.bin Unable to set this url, file has non-ASCII characters
I have a 5505 that won't pass ipsec traffic from a software client, this is the error that I get from the logs.regular translation creation failed for protocol 50 src inside:192.168.1.151 dst outside:xxx.xxx.xxx.xxxa search of the cisco site turned u...
I am getting ready to install an IDS/IPS appliance on my network, and while most of the traffic from my 3005s is routed to a 3640 for distribution. But, I need to make sure that nothing is being routed internally in the 3005, but it all traffic is be...
Question: since DLCI's are only locally significant is there a problem in assigning the same DLCI numbers (different providers) on seperate interfaces connected to different frame circuits.
Ok, this is what Tac had to say:The problem is the command you are using, instead of using boot config disk0:/asa802-k8.bin the correct command is:boot system disk0:/asa802-k8.bin Funny thing was I was using the ADSM upgrade tool and not the CLI, so ...
I'm afraid that I wasn't being clear. In order for the IDS/IPS to examine all traffic, it needs to be able to look at the unecrypted data flow. That would mean that traffic between two 3002 clients terminating on the same 3005 would have to be routed...
