Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi , I have setup FWSM in my lab , and configured a security context named it "test" and configured 3 vlan interfaces on it. I have disabled the NAT between these interface traffic. below is the setup. inside - 10.1.3.1 / 255.255.255.0inside-2 - 10....
We have three servers with IP 172.16.10.1 connected to three different switches (trunked together)but I am seeing Duplicate Address error on one of the server and that too on alternate day basis e.g. 7th July then 9th July and then 13th July. Am expe...
Hi David, ip wccp redirect in & ip wccp redirect out shouldn't be used on the same interface. You will have to identify the Source traffic and apply redirect in at the incoming interface and identify the return traffic and again apply redirect inAr...
Thanks Guys for the clarity on the command, i mistook this command for the cisco source interface option. However I have been facing problems in ping between the servers connected to inside and inside-2 interfaces as mentioned in the 1st post of thi...
Please find the outputs below. permit inter-interface was already added. FWSM/test# sh nameif Interface Name SecurityVlan100 outside 0Vlan101 inside ...
