Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Afternoon,I have an ASA 5525-X on 9.12.x. We have been working with TAC to try and migrate our ASA config to a Firepower 2120 running FTD code. We also have CDO. We are hoping to use CDO's ASA to FTD conversion tool, but so far as been wildly...
Good Morning, We recently changed our internal DNS Servers and were looking to change them on the firewall. When we did, the firewall was no longer able to resolve addresses. We failed back but noticed that in the ADSM that the outside interface wa...
Good Morning/Afternoon/Evening/Day, Current infrastructure:6509e Chassis with supervisor cards and blade switches purchase ca2011 Future:3850s/9300s Stacked Switches Network:We have an 10gbps Single mode fiber running between 4 6509e. We have an E...
Good Morning! Thanks for reply. The ASA does have a FIrepower Module. We are not trying to move that instance.I have a meeting with Cisco at 2 to try again...
Thank you for your input. We will be looking more into upgrades in 18-24 months, so I will make a note in the project about 9000 series.have a good Day.
Good Morning, Thank you all the responses. I was just counting my fiber connections and I think a 24 port fiber switch would more cover current capacity and provide for growth, and then replace the 3 48-port blades with either the 3650 or 3800 serie...
Good Morning, Thanks for replying. My goal- to replace as many of the 6509 as possible within the budget. As far as equivalent replacement, I need the same/if not more port density and the ability to do etherchannels between the sites on campus. I ...
