Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I would like to get a list of the associated APs on my controller. I would like the list to show the name of the AP, the Ethernet MAC, and the Base Radio MAC address. I planned to do a show run-config, save that information to a file and then...
weterry wrote:I'm not aware of a single command that shows all APs and both MAC addresses (but it might exist?). Maybe an AP Inventory report in WCS can do it?In the show run-config, you are correct that the AP Config section shows all the informatio...
leolaohoo wrote:I would like the list to show the name of the AP, the Ethernet MAC, and the Base Radio MAC address. I hope you like doing this CLI because the command is: sh ap config general I planned to do a show run-config, save that information ...
