Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a layer 3 switch (Cisco Catalyst 3560) with multiple vlans configured on it, and connect to this switch to the inside interface of ASA 5510 (default VLAN IP) All vlan have L3 interface with IP address, and for the clients the default gateway i...
Hello,
I have a layer 3 switch (Cisco Catalyst 3650) with multiple vlans configured on it, and connect to this switch to inside interface of ASA.My goal is make all vlans can go through firewall and asa route beetween VLAN-s not Layer3 switch.Inside ...
Hello guys,
I have a problem with ASA. I attached the topology of the network. Now we have 2 core switches which are route within VLAN-s. Now I have to insert in these topology 2 ASA (active/standby). The goal is that the 2 ASA control the traffic ...
Okay, That means I need to create subinterfaces for VLAN-s on ASA, eliminate the L3 interfaces on switch (except default VLAN). But what about default gateway of the clients of the VLAN-s? Do I have to set the IP address of the subinterfaces to same ...
Hello Paul,
Thank you for your reply, I understand this solution. I try to find a solution which require the minimal change of the current configuration of the core switches because these network has to work continously. So what is your opinion about...
