Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I'm actually trying to set a WLC 5520 Wireless Controller up, to manage my aironets APs on two differents (isolated) physicals networks.Wlans on network 1 are only linked to vlans on network 1, and Wlans on network 2 are only linked to vlan...
I think i am going to add a switch at the controller level. So i will beable to share managements vlans between both networks, and isolate clientsvlans by limiting allowed vlans on each ports.This is the only solution I see. I just wait for the answe...
No, Management and AP Managers interfaces doesn't need to be on the same subnet, but they have to be reachable by the AP.As management interface only manages discovery requests, I made a route to it from 2nd network.But I can't route all the AP manag...
It has always been disabled, and I tried to reboot both controllers at least 2-3 times What I need is to choose which AP goes on which AP manager.I made a wireshark to see exchanges between AP and controller during discovery/ join phases. In fact, t...
"If an AP, with an configured prefer-mode, tries to join the controller and fails, then it will fall back to choose AP-manager of the other transport and joins the same controller. When both transports fail, AP will move to next discovery response."S...
