Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I am an amateur when it comes to the true science behind some of what I am trying to configure so I love to hear explanations as to why it is not working, as well as get it fixed. I have a Cisco 5540 running 9.1. I have an outside, p_wir...
It was worth a try. Can you post your running config so I can try to mirror it? I know the server is not listening on 443 because I have analyzed the netstat listening ports and that one is not listed. If anything it might be listening on 8443, bu...
That is surely my fault. I did remove that during some testing and forgot to add it back in. I have corrected that and done some packet tracing based on a review of your lab and I setup port 23 to isolate traffic and hopefully make things easier.I ...
Sorry, for the running-config while prepping all the data. interface GigabitEthernet0/0mac-address 0026.9986.77afnameif outsidesecurity-level 0ip address 192.168.3.4 255.255.255.0!interface GigabitEthernet0/1nameif p_wiredsecurity-level 50ip address ...
Thanks, I just wanted to ask about that other stuff because that "destination" NAT statement was something I had not seen before. Below is my updated running-config based on your recommendations. I also provided the capture on the outside and dmz i...
Thanks, I just wanted to ask about that other stuff because that "destination" NAT statement was something I had not seen before. Below is my updated running-config based on your recommendations. I also provided the capture on the outside and dmz i...
