Hi,The command "ip directed-broadcast" seems not working, for the following configuration:interface e0 ip address 10.1.1.1 255.255.255.0 no ip directed-broadcastwhen do a "ping 10.1.1.255", I still can get reply from the hosts directly connected to...
Hello,To define the dlsw interesting traffic for DDR, we have to methods:1) access-list 101 permit tcp any eq 2065 any access-list 101 permit tcp any any eq 20652) dialer-list 1 protocol llc2 permitWhat is differences between this two defination? ...
Hi,For the ISDN snapshot routing, during the quiet period, the routers are supposed to froze the routes from aging out, but it seems that the snap client does froze the routes, but the snap server doesn't, why? Is this normal behavior?ThanksFujin
Hi,We know that BGP maintains a different routing table from IP, and there is procedure to compare the Attributes in order to install a route into IP routing table.My question is that is there any criteria to be met in order to install a route into B...
Hi,I'm confused with different type of peers: TCP, Direct, and FST. How do they work together?I have seen configurations with two router over frame relay, both router uses both TCP and Direct frame-relay peer configuration, why it is needed to use bo...
Hi,I got the same situation with you. and I tried on 12.1 and 12.2. The cost in "dlsw remote-peer" doesn't work! One thing I notice is the default value is 3 instead of 2. I checked the cisco document,it says no default value!Anyone got any idea??
but are you able the explain the case that I describe above? Here I repeat it:router A, B, C, D, E connected as circle, each router has a different AS. router A advertises a route 10.1.1.0/24, by right, router B should have two paths to network 10.1....
Hi, thank you, haas,But I think you mis-understand my question, I'm talking about the BGP route advertisement and BGP routing table maintainenace, not IP routing table.Anybody got any other opinion?