Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Rick, our task were to change the SD-WAN image on the router to standard IOS image to do that i was not able to going in the configuration mode with the SD-WAN image. When i type „configuration terminal“ got an error message this command isn’t suppor...
Hello, I had the same problem also and found that the router has a SD--WAN image try this command in enable mode: controller mode disableand answer "confirm" twice.After reload the router you should able to enter the configuration modeBRNael
