Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, This is my first post, please be gentle. I have 3 routers (All ISR4321 routers) with these configs: ---------------R1-----------------int s0/1/0ip add 10.1.1.1 255.255.255.252en frame-relayno frame-relay inverse-arpframe-relay map ip 10.1.1....
Hi Paul,Physically, R1 S0/1/0 is DCE and R2 S0/1/0 is DTE - that's normal set up in my lab. In the lab file, the instructions say to make all R2 interfaces logical DCE hence the conflicts. However, it also explains in the lab (page 4) that:"Changing ...
Hi Georg,Sorry I'm not sure what NIM version it is but I've attached the result of show inventory to this post.I've configured 'network-clock synchronization automatic' on all routers but still same result.Thanks Georg anw for replying to my post.
Hi Georg,I've re-read the lab file again. It doesn't require to configure clock rate on the hub router (R2) as the DCE here is only logical. Also, I've tried same commands on another three 2811 Routers (running IOS Version 15.1(4)M10, RELEASE SOFTWAR...
