About Magesh Kumar

Magesh Kumar · 10-18-2024

Hi team,We've Cisco 9200 catalyst switches in INSTALL MODE, while doing the switch upgrade we are following all the steps given in the Cisco official release note, Example, https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9200/software/rele...

Magesh Kumar · 05-27-2024

Hi team,I have captured some TCP traffic in Cisco ASA. But from that capture, I'm unable to examine the TCP handshake flow.Looks like, TCP flags are placed in random order. Is ASA capturing the traffic in sequence order?What is the flag for SYNC ACK...

Magesh Kumar · 11-16-2019

Hi team, What is the exact difference between Manual NAT and Object NAT in Cisco ASA? With Regards,Magesh Kumar G

Magesh Kumar · 10-18-2019

Hi all, We are planned to Implement command restrictions for different users in our Cisco Routers, Switches and ASA. For testing purpose, we have already hardened one of our router using privilege level commands. Its working fine, but for that we hav...

Magesh Kumar · 09-27-2019

Hi All, One of our MPLS Circuit Continuously Fluctuating. Our Environment like PE (Alcatel) to CE (Cisco) Router. This fluctuation will Reset the BGP Session with following logs (BGP state went down and after some seconds automatically become up) Sep...

Magesh Kumar · 10-18-2024

Hi @Flavio Miranda Before running Install mode commands. @DanielP211 @Leo Laohoo So, we can skip the "SET BOOT VARIABLE" step? Right? During software upgrade?

Magesh Kumar · 06-01-2024

Looks like problem with Destination server. After restarted the services in destination server, ASA capture showing TCP handshake sequentially.Thanks all.

Magesh Kumar · 05-27-2024

Yes. I've created capture with source and destination IP's.Thanks,Magesh Kumar G

Magesh Kumar · 10-23-2019

Hi Balaji, So you mean both are doing same function, Right? Then why we need two separate command for same function? With Regards,Magesh Kumar G

Magesh Kumar · 10-23-2019

Hi Georg, Since Alcatel router was maintained by ISP, I can't provide that router configurations. As analyzed our CE router configuration, I found that no ip unreachables configured under PE facing interface. BGP Logs: %BGP-3-NOTIFICATION: sent to n...

Member Since	‎04-29-2019 03:11 AM
Date Last Visited	‎11-12-2024 11:21 PM
Posts	18
Total Helpful Votes Received	2

User Statistics

User Activity

SET BOOT VARIABLE IN INSTALL MODE - CISCO 9200

Packet Capture - Cisco ASA

Manual NAT vs Object NAT

Role Based access control vs Privilege Level

BGP between Cisco and Alcatel Router

Re: SET BOOT VARIABLE IN INSTALL MODE - CISCO 9200

Re: Packet Capture - Cisco ASA

Re: Packet Capture - Cisco ASA

Re: switchport mode trunk vs switchport trunk allowed vlan all

Re: BGP between Cisco and Alcatel Router