Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an RV340 connected to a SG350 and a SG300, all wired with Cat 6. The two AP581 ports are automatically LAG1, I have the two SG350 ports as LAG1. I have tried every setting possible and have yet to achieve 2.5Gbe with this access point.
Patoberli, thank you again for the completely useless information. The 2.5 Gbe is a SETTING in the WP581, so it is, supposedly, possible. The WAP581 will not operate with the port set at 2.5 Gbe in my setup. My question is how to set my equipment to ...
@patoberli wrote:This is not achievable on the wireless though. With an 160 Mhz channel and a 4x4:4 client you can probably reach a maximum of ~900 Mbps. From the WAP581 Datasheet: Provides cost-effective 802.11ac Wave 2 connectivity with speeds up t...
@patoberli wrote:This is not achievable on the wireless though. With an 160 Mhz channel and a 4x4:4 client you can probably reach a maximum of ~900 Mbps. From the WAP581 Datasheet: Provides cost-effective 802.11ac Wave 2 connectivity with speeds up t...
I am looking for the solution to how I achieve the 2.5 Gbe, not your opinion of whether I need it or not. Funny though, Cisco "Engineers" can't explain how to do it either.
