Hi All, Is there a way where we can allow traffic from outside interface with security-level 0 to Inside or DMZ interface with  higher security-level apart from ACLs ? I mean without any acl entry can we allow traffic?Is there any other way  traffic ...

Hello,   In ASA failover all interfaces whether they are monitored or not (using no monitor-interface) will switch their ip addresses when  failover occurs or via 'failover active "command. my question is : Is there any possible way by which we can f...

Unable to establish vpn session using aggressive modehelp neededR1: crypto isakmp policy 10 encr 3des hash md5 authentication pre-share group 2  crypto isakmp key cisco123 address 10.1.12.2 !         crypto isakmp peer address 10.1.12.2 set aggres...