Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allI have a Cisco 1841 router and Cisco 2800 series router.I am trying to setup a pppoe session with vlan tagging, however I have a challenge when I need to insert the below command into the sub-interface " pppoe-client dial-pool-number 1" " NAMIB...
Hi Are you able to send me a config with "Otherwise if you have a LAN switch you can define Vlan 200 over it, use an access port in vlan 200 towards the router and a trunk port towards the ISP that allows Vlan 200" This would be greatly appreciated. ...
