Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys, The client is getting IPV6 IP Address instead of IPV4 IP Address from the DHCP pool. Please see image below for reference.Is there a workaround on this issue. Thank you.
Hi Leo, Please see below config. CORE-SW#sh vlanVLAN Name ---- --------------77 Wireless-Guest-New active CORE-SW#sh interface Ten 2/0/39 trunkPort Mode Encapsulation Status Native vlanTe2/0/39 on 802.1q trunk-inbndl 1(Po20)Port Vlans allowed on t...
Hi Leo, Good catch! Please find below existing config and let me know if I can change and configure a trunk on the following interfaces. *vlan 50 - management *vlan 77 - new guest wifi Please advise if this is correct. Trunk sample config:!interface ...
