Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a problem with IOx server failing after a certain time. The server works fine but then drops out the first time GI0 loses connection. After that GI2 can't be reached anymore and my docker application loses connection. I have provided logs ...
Hi, I was trying to find some documents/code-snippets or repositories which demonstrate how to use CANbus with iOx platform. However, I was not successful in finding any relevant resource on the topic. Could anyone point me in the right direction? Be...
@Emmanuel Tychon one more curious thing. This happens repeatedly 24 hours after the docker application was started. So it doesn't have anything to do with dropping the internet connection... Any clue about this curious issue?
Also check out the result of sh ip arp before and after the reload.... WeInt0#Show ip arpProtocol Address Age (min) Hardware Addr Type InterfaceInternet 192.168.1.1 0 749d.7995.ff20 ARPA GigabitEthernet0Internet 192.168.1.5 6 9061.ae81.6f46 ARPA Giga...
Hi,So after approximately one day, the docker application lost its connection again. My laptop is connected over wifi to my home network, and the router is connected to the router by a cable. I am sending you the screen snapshot and the output of the...
Hi guys,I really appreciate your efforts. I have to say the whole setup behaves a bit flaky, and unpredictable. I am trying to get some meaning into all of this.Application is a simple modbus master that polls 3 values from modbus sensors and sends t...
