Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My understanding of IPv6 may not be accurate, so if there are any incorrect statements, please correct them.We have a requirement that prohibits FE80::/10 addresses from passing from end sites to the provider network. FE80::/10 are the IPv6 link-loc...
Hello everyone,We have a CSS11503 that is currently being used to accept incoming HTTPS and SSH connections on a specific VIP and then PAT those client connections. I understand that it also PATs the server initiated connections. !******************...
How do I verify that hosts on different VLANs have connectivity? I can't ping from a host on one VLAN to a host on the other VLAN even with a policy that allows ICMP in place.
Thank you. I think this is something that we can use.The problem is that we have an explicit requirement to block all link-local addresses, and I'm trying to figure out what that breaks. It breaks ND, but does that break everything since one of the...
Yes, I agree that the requirement is not necessary since link-local addresses aren't propagated; however, it's a requirement that my organization still has to meet. We are required to add these two statements to our router at the perimeter of our ne...
Just as a follow up, this explains my question better -From the Routing and Bridging Guide vA2(1.0), Cisco ACE Application Control Engine Module -"For security reasons, the ACE does not allow pings from an interface on a VLAN on one side of the ACE ...
