Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The 'Pipe' command | (shift + backslash key) does not work in Packet Tracer for me. Is the pipe command supported in Packet Tracer? If not, is there anywhere official online that confirms that the command is not supported?
Thanks for you response! I'm doing an online video course so am just following the exact same steps as the tutor. You'll see from my attachment that I've put in a show run and the 'pipe', but PT highlights it as invalid. (You mention the '?', but on ...
