Looking to upgrade the FTD OS on a Cisco ASA 6.2.3 to a 6.6.0 or higher. IS there a step by step process to follow. these ASA are managed through FMC. The guide mentions to upgrade the firmware on the FMC before upgrading the firmware on Cisco ASA's ...
Hi All, I am having a problem is routing traffic towards my ASA VPN tunnel below is the requirement Remote VPN Network: 192.168.66.0/24Local Network: 172.20.30.0/23Traffic from 172.20.30.17 host is set to go to default GW 172.20.30.1 which is Cisco2...
Hi I am trying to configure High Availability on two Cisco ISR 4400 series routers. Each router has 4 interfaces. I have to connect both routers directly, as we have only 1 switch. I am thinking to use Gi1/1/1 on each interface to be connected direct...
So If I understand correctly, can we follow the upgrade procedure defined for Firepower device managed via FMC since not a clearly defined procedure exist where ASA is running FTD OS?
https://www.cisco.com/c/en/us/support/docs/security/firepower-man...
hi balaji,
thanks for your input. Basically the link shared talks about CISCO ASA 9.xx version. In my case it is different it is a Cisco ASA 5508-X on a 6.2.3 FTD firmware managed by FMCv. As per compatibility matrix i can go from 6.2.3 to 6.6.0 or ...
Hi So i was able to resolve the issue. i defined a static route on router so all traffic from LOCAL LAN towards Remote lan to be forwarded to FW inside interface and in acl i allowed the traffic on the inside side. i am able to ping now and can rdp a...
