Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all bros, Assume I have 04 AP1852E access points with mobility express image. On the document page on Cisco, I just find how to configure an AP1852E as Mobility express controller and it said in a network we can have only 01 controller (so only 01...
Thank for the help, 1. Can you give me a link for guiding how to configure AP IP address by CLI? I just want to configure all AP with static IP before it joining the virtual controller. 2. Is IP address of Capwap image AP and mobility express image ...
Hi pieterh, Thank you. I want to ask: 1. After configuring mobility function on an AP, so the AP get management IP (ME IP address). After that, Can I configure AP IP address for itself (AP IP address like normal AP). 2. If Master AP [old] down, then...
Dear pieterh,I want to ask about the addresses of AP.1. If I use a DHCP for assigning an address to APs, do I must specify option 43 (with value is management IP of master AP)?2. Can I assign addresses to APs statically? For example, I want to config...
Thank you, 1. So I just need to configure controller function for 01 AP, and all other APs need to place in the same network (eg: same VLAN) with no more configuration required to join to master AP.? Am I right? 2. And if AP come with mobility expres...
This link guides me on how to join an AP to a master. But, how can I configure it to take over the master role when the master AP failed?. Please help.
