Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, first off let me start by saying I am very new to this so I apologize ahead of time but am very eager to learn. I have a WLC 5508 and a Catalyst 2960S as well as 3 AIRCAP 3502E access points. I have read books and watched tons of Youtube v...
Ok....Update time. So I went out and bought a Cisco 2821 router and an ASA 5505. I installed them and did a very basic installation. I was having trouble for a while with this until I realized I had competing NAT's. I disabled the Nat or put it in p...
Thank you to everyone for your expertise and sharing your knowledge with me on this matter. I think ultimately what may be going on is that I dont have a Cisco router. I have been using the AT&T modem/router plugged into port 1 on the 2960S. At first...
Thank you for your help. I am not able to get the ap info as I cant get them to join. I was able to get the sys info and the time. Again I appreciate your help. I really just want this to work. I need some guidance for dummies. For that matter I boug...
Thank you for your reply. Since my last post I created a couple of VLANs. I created a trunk to communicate from switch to switch. I reconfigured the wlc ( for the 100th ) time and specified it to be on it's own vlan. I did choose the static option in...
I am stuck with the fact that the ap's wont show up in the wlc management. I feel like maybe i didnt set the switch up right or don't have something connected right. I am beyond frustrated. I ran the network assistant and this is what it shows me. I ...
