Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All ,Hope you all are doing wellI did a test and get some results and I need your opinion about the resultson the attached topology I did IPerf3 as the following - 512 K bandwidth test from PE-01to PE-02 (Fixed )- increasing the bandwidth betw...
Dear All , I am doing my thesis on Segment Routing and trying to show the benefits of SR by using GNS3 and building a network and implementing SR and testing some use cases I'd need your help and suggestions the network is as shown below the IGP is ...
Hi All I am trying an Iperf3 test however it is in GNS3 but works fine for low BW testing but not for higher BWwhile testing BW till 512 K it is ok and i can notice the transferred packet is about 64K but while increasing the BW to be tested i can n...
Dears Hope you all are doing well I have a network topology of 8 Routers on GNS3 and using IOS XRv 6.1.3 I configured OSPF and then Segment Routing when testing the Link performance I found a huge delay and latency after segment routing I feel that E...
Hello Giuseppe , Many thanks for your reply yes i think if there is alternative routes there should be a sort of re-routing but what if i forced the traffic to go through this route or there was no alternative routes is that an advantage to keep no ...
Hi Giuseppe, Many Thanks for your continuous support What i saw in my test is that however i didn't force the traffic to another direction and let it go to P_04 using IGP the performance got better when i used SR Does that show a benefit os SR ? ( Re...
Thanks Giuseppe for your continuous support yes I am trying to set the MSS size but unable to set the correct one Also is that with TCP only I am also using UDP in the test (-u) I am testing after and before Segment routing and using 2 Labels for Se...
Hi Giuseppeanother question regarding the Iperf test while testing BW till 512 K it is ok and i can notice the transferred packet is about 64K but while increasing the BW to be tested i can notice that the packet is increasing and that affect the te...
