Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community,I am using IOx local manager to deploy my docker app on IR809. The container could start/deploy and run until I changed the package.yaml for adding USB serial access. For this, the upgraded package.tar has the following package.yaml :app...
Hello Community, I am using an IR809 router. I could establish GE0 connection successfully. But GE2 I intended for accessing IOx manager is not working out. It should give me the manager at port 8443 of my GE2 IOx host IP 192.168.1.3, but it is not.i...
Hi Community, I am using ASIX AX88179 USB-to-LAN connector for connecting IR809 router to my centos7 VM. I get the following "state to up" for GE0 while I connect the initially to pc (or I remove and connect again):*Jul 12 15:23:21.130: %LINK-3-UPDOW...
Hi pieterh, Solved!!Yes, "root" does not exist by default. Also, I was doing wrong simply using "root" instead of "username" - Misled somewhere reading the docs Was not expecting this username would be used by GOS!! After a few tries, I gave my use...
Hello Peiterh and Georg, I am able to telnet now. Issue was the IP, didn't know it would auto resolve. ir809#telnet 192.168.1.1 2070
Trying 192.168.1.1, 2070 ... Open
Searching bootor
MontaVista Carrier Grade Express Linux 2.0.0 ir809-GOS-1 /dev/con...
Hi Rick,Issue resolved.I was using VM player. Suspected, VM host networking issue + asix drivers. So, I tried with my ubuntu installation. Now link is not going down. Using duplex "auto". ir809(config)#do ping 192.168.0.2
Type escape sequence to abor...
Thanks Rick!I was trying "auto" previously, assuming it will take half duplex. Now specified "half", that too making the link go down after few seconds.Should I specify anything else, related to RJ45.? Also,I am getting a warning related to the drive...
