Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 switch installed model is C9300L-48P-4X. I didn't configure the switch priority and by default, both switch has a priority 1. Switch 1 is Active and Switch 2 is standby. Switch 1 - Uplink Te1/1/1 is connected to a Cisco 4500 switch 1 (VSS)Sw...
Our server team advise us to check the L2 switch on the issue that the DHCP server running in windows has a 30s delay when leasing an IP address to a workstation. Connection is only through local area network. The DHCP server and the workstation are ...
We don't configure PO on this setup since connection going to the 4500 is configured with VSS. We have no other issue with other floors on the building. The only difference is that this access switch is 9300 and the other existing are 2960.
We have the same setup with other floors, same config on the uplinks. The only difference is that this model is 9300 and the other that are working is 2960. Currently, connection are stable but we only activated one uplink (Te1/1/1) in the 9300 going...
