Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just updated my SG300-28P to the latest firmware, 1.4.11.2, after previously running 1.4.10.6. Previous to the update, I could access the Web interface with the hostname I'd specified in System Settings (as part of the FQDN I use for my LAN), i.e. ...
I wish to use SSH public key authentication between my computers and a specific user account on the switch. This works fine from my laptop - I just add my laptop user's public RSA key to the switch's user account via the Web interface. The problem co...
@balaji.bandi- The most recent release (1.4.11.02, 16th October 2019) fixes CSCvp23218, but does not fix the 'domain vs IP' issue people are reporting here. The domain / IP issue was actually introduced with the most recent release.
To add to rpc's reply, I can also confirm hostname access works again after rolling back to 1.4.10.6.With 1.4.11.2, everything works fine by IP but I get a HTTP 400 Bad request when using hostname.
Thanks for the reply, Georg.Yes, I can certainly do that this weekend, no problem. I will report back here as soon as I can.Do you know, will I need to reset to factory defaults when downgrading? Or should I be able to keep the same config? I will ma...
Sorry to hear you're having the same issue, although I must admit, it's nice to know I'm not alone!I plan to do some further digging over the weekend. If I find out anything further, I'll make sure to post here.
Just had another look at the Cisco email notification I received regarding the vulnerability. It says:- At the time of publication, Cisco fixed this vulnerability in the following firmware releases:Cisco 200/300/500 Series Smart and Managed Switches ...
