Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
helloi've got a problem with vdsl over pppoe. i've got a cisco 887VA and now want to connect to my ips with the credentials they gave me.the cd-led (carrier-detect) is constantly flashing, means i've got a connection to the isp. but the ppp doesn't c...
HiI have a problem with my Cisco 887V VDSL-router. The router gets a ip-address with dhcp from my provider. That works fine. I also can ping from the router:routerVdslTestNew#ping google.ch source vlan 1 Type escape sequence to abort.Sending 5, 100-b...
Hello everyone!I just found the solution to my problem by myself! My Problem was that I used the “interface ATM0.1 point-to-point” instead of the Ethernet0 interface!The ATM0 interface is only for ADSL, not for VDSL. So i just configured the Ethernet...
Well if I would be an expert I wouldn't ask in this support community.My ISP said that the configured MTU works. But I'm not sure if I configured the interface Ethernet0 correct:interface Ethernet0 no ip address no ip redirects no ip unreachables no ...
My ISP said that 1492 as MTU or less should work.Do you think that the connection works if do these changes:interface Ethernet0 no ip address no ip redirects no ip unreachables no ip proxy-arp pppoe-client dial-pool-number 1
I just checked my config again and saw, that the „interface Ethernet0“ looks like this:interface Ethernet0 ip address dhcpIsn't that wrong? Shouldn't it look like this?:interface Ethernet0 no ip address no ip redirects no ip unreachables no ip proxy-...
Thanks for your answer! Sorry, i meant the LED is burning. I can’t execute the command “show dsl interface” on my router, but I’ve uploaded some other logs which might be useful.
