About bairdj3

bairdj3 · 06-10-2002

Hello,What information does the 'show buffers input-interface' IOS command provide on 'MLS' or 'CEF' enabled switches (i.e. Cat 6500s with MSFCs).As I understand on traditional software routers (i.e. 2600, 3600, 7200, etc) this command will provide t...

bairdj3 · 01-23-2003

Certainly - simply create a virtual interface for VLAN 2 - once the new interface created you can treat it just like any VLAN interface (use the same syntax for VLAN 1 except swap the 1 with a 2)Hope that helps .

bairdj3 · 11-13-2002

Author: Radia PerlmanBook: Interconnections: Bridges and routers 1st or 2nd editionSince STP was an IEEE initiative you could also get a copy of the 802.1d spec

bairdj3 · 01-17-2002

Hello,The default behaviour is that as long as there is an *active* port on the switch which belongs to the vlan for which the VLAN interface is defined the VLAN interface will NOT go to a 'down/down' status which results in poor or no Layer 3 failov...

bairdj3 · 12-06-2001

Hello,It has been my experience that at this point in your PD process a sniffer would be your most valuable tool.

bairdj3 · 12-06-2001

Hello,You are NOT alone - we have seen these same symtoms with the same hardware platforms you mentioned. We have had a number TAC cases opened as well as NSA involed to no avail. I will scope out the link provided by the gent from Cisco.

Member Since	‎10-26-2001 06:03 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	10

User Statistics

User Activity

'show buffers input-interface' IOS Command

Re: Can you add a ip address to Vlan 2 on cat 2900 switch

Re: STP Theory

Re: Logical Interface VLANXXX does not go down

Re: logging in to IPX in cat3500XL environment

Re: Gigabit Uplink Modul U5534