Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I hope someone can help me with this capture.I have an ASA configured to authenticate towards an AAA server, with the following config:aaa-server RAS-Server protocol radiusaaa-server RAS-Server (if-inside) host 10.10.6.5key *****authentication-...
Hello all, I'm new in this community, thanks for your help in advance. I have a switch Catalyst 2960-X (specifically C2960X-24PSQ-L) that has been taken from one location and I have no idea what the enable password might be.So I have followed the pro...
Hi @Marius Gunnerud , Thanks a lot for your help. Someone went to the datacenter and connected the interface so now it's up. For more clarity, the host from AWS that is the one that has to access the ASA, I will call AWS_host (10.15.1.2) The VPN pat...
OK, so after a lot of struggle now Im told by Cisco engineer that tunneled traffic cannot be captured. This is probably very basic but I'm surprised that it took this long to be spotted Thank you all for your kind help
Thanks for your suggestions, but none of them worked. I spent one hour in webex session with Cisco tech engineer, but no luck. show capture
capture capin type raw-data interface if-inside [Capturing - 0 bytes]
match udp any host 10.10.6.5
capture c...
So it was indeed a hardware problem!!A colleague of mine helped me out, we opened the device, located the switch under the mode button which was totally loose. He soldered it back to its place. Then the problem we had is that once we put everything...
