About beohu

beohu · 06-04-2020

Hi guys,My port-channel (gi0/47, gi0/48) of 2960 switch connected to a stacked 3750 (contain 02 switches stacked, on 1/0/24 and 2/0/24). Sometimes the 2960 switch is suspended (I have to restart it to make it works), on the 3750 I see the log like th...

beohu · 02-28-2020

I have a new switch WS-C2960L-48TS-LL with IOS Version 15.2(6)E2b. I configured a port-channel (contain two port) and want to use load balance method src-dst-ip. But when I type the command port-channel and ?, it just show like this: #port-channel ?...

beohu · 06-04-2020

When the 2960 SW suspended, I couldn't log in by telnet or console to get the log, I must restart it to recover network that the switch cover. After restart the 2960 SW, I checked port-channel on both ends, it seems configured properly.

beohu · 03-01-2020

Hi marce1000, I have set the port-channel on the interfaces, and the port-channel run well. But when I tried to config the port-channel load-balance command, it not show anything except auto command. On the previous switch (WS-C2960-48TC-L), I still...

Member Since	‎08-22-2019 07:58 PM
Date Last Visited	‎06-20-2021 11:53 AM
Posts	4

User Statistics

User Activity

Mac flapping between two port of a port-channel.

port-channel load-balance command not show (C2960L-UNIVERSALK9-M), Version 15.2(6)E2b

Re: Mac flapping between two port of a port-channel.

Re: port-channel load-balance command not show (C2960L-UNIVERSALK9-M), Version 15.2(6)E2b