Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All
Need advice on the following:
Have a ASA (version 8.2) configured as a EZVPN client, the EZVPN server is a ASA at another establishment which we breakout from. All traffic from inside has to go through the VPN for connectivity.
The ASA has a...
Hi All
Need a bit of advice on whether the following design to add redundancy will work:
Current setup:
Access Layer switch Interface Gi1/0/1 (trunk) ---> Datacentre 1 Core switch Gi1/0/1 L2VPN XCONNECT VC 1210 ----> Datacentre 2 Core switch Gi1/0/...
Having researched, I found another option:
- Create a new VC to run parallel to the current VC on both ends, then specify the new VC as a backup peer of the current VC.
This means only the 2nd link / VC will become active if the current VC fails.
M...
Hi
This sounds the best way to go, please could you describe what config changes are needed to the current interface config below, to "to use port based EoMPLS OR L2 protocol tunneling over EVC based EoMPLS."
DC 1 Core switch:
interface GigabitEth...
change of setup, since the EoMPLS is just point to point, essentially Layer 2 between the switches in each DC. I will let Spanning tree just block one link at either end.
Question is, are BPDU's sent over the pseudo wire between the switch stacks??
Hi Guiseppe
Thanks for your reply.
With regards to
"you need to configure two parallel pseudowires on two different edge interfaces"
Can I use the same PW VC (1210) on the new interface or have to provision a new VC?
Is it possible to use use th...
