Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi fellows,I am using 2 cisco 1941 routers, each have separate 500mbps internet link locally located for redundancy.GLBP protocol is running for redundancy on a configured virtual gateway perfectly. My question is that, One router state is "Active" a...
Thanks for information. Right it is not that much bad speed as compared to router throughput.Can you please suggest any configuration / technique so that i can test for load sharing. I mean both router resources should be used. No matter for speed.
