Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Beat me to it. Those would be the correct commands. Thanks Chris!
You may also want to also run the below command because I have seen some scanners ding WLCs for having RC4 ciphers in use as well, but ultimately would depend on your security poli...
Those commands are not for a WLC. What you are looking for are the secureweb commands that you referenced. To enable SSLv3 use the following:
config network secureweb sslv3 enable
To ensure higher level TLS encryption ciphers, use the following:
c...
