Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there any way that Snort can still block or drop a packet/traffic even if i already added a prefilter policy that sets as any any network and with fastpath? Also i have disabled all my access control policy except for default ACP that is set to "T...
Hello everyone, May i ask if there is a way to configure a dual wan load balancing with a 50%/50% ratio on both outside interface using FMC. Right now my current config is just basic failover. I have a FTD 5508X v7.0.0.1 and FMC v7.0.0.1 Thanks to yo...
Hi Sir,we finally found the culprit with the help of TAC. i sent TAC the bug report link that was showed here an they confirmed that i hit the similar bug and disabling early application detection and url categorization helped fix the problem,TAC wer...
My topolgy is this:ISP <-> FTD-ASA5508X <-> Cisco 3850X-Core Switch<-> Internal LANFTD data port - XXX.21.1.1FTD mgmt port - XXX.20.1.31Core - XXX.21.1.2
Can you show the ACP rules created if possible? Can you run show asp drop from the ftd cli? Also can you check if TLS in advanced tab under ACP is enabled? (This is done under Access Control Policy > Advanced > TLS Server Identity Discovery > Early A...
