Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,TOday we setup LINMIN (automated OS provisioning) for our server farm. We have about 350 servers, each server is on its own SEPARATE VLAN with a subnet of /29 for IP's. So every server has his own private vlan.The dedicated servers are mostly i...
Hello,We have:ISP-AISP-BBOTH ISP's have BGP passwords set.We want to be multihomed with those ISP's, but we have 4 blocks of IP's to announce.208.65.XX.XX /22208.66.XX.XX /22208.75.XX.XX /2276.76.XX.XX /19Basically what we want done is setup multihom...
Hello,Ok so this is what we currently have.ISP1 = MTOISP2 = COGENTOur current Switch Config is:router bgp ASN_NUMBER no synchronization bgp router-id XXX.XX.60.1 bgp log-neighbor-changes network XX.XX.96.0 mask 255.255.224.0 network XXX.XX.60.0 mask ...
Hello,Recently we have changed over to BGP for our SINGLE PROVIDER we currently have.The configuration looks like this:router bgp AS_NUMBER no synchronization bgp router-id ROUTER_ID_IP bgp log-neighbor-changes network XXX.XXX.XXX.XXX (1) mask 255.25...
Hello,We currently have IP's from ARIN routed on our ISP's BGP. We provide them our IP subnet info and they put in their BGP and route them to our interface on their switches...Now we received our own ASN from ARIN and we want to migrate over to doin...
Ok but they are the same IP. The PXE server runs as a DHCP server and they are on the same IP.May I add that maybe the problem has to do with inter vlan talking? The two servers are on different vlans and their vlans are assign different IP subnets.D...
Hello,thanks for the reply, but what do you mean by check the IP addresses allocations?No access list on our switchYes the dhcp server pings fine from the 6509Thanks
Ok I removed the "no service dhcp" on the 6509 switch and added ip helpder address to the proper vlan in question, but it is still not picking up when booting from the network.Anything else I can look at?Thanks
I wanted to add, that the 3 other networks should route always through ISP-A when it is available and not down.Basically, I want the 3 ISP's to advertise all my routes and then I control what goes out from where.Thank You
Ok so finally we got it to work as mentionned in the above configs, only thing remaining is that the router chooses COGENT as the default 0.0.0.0, I need all the traffic that is NOT from the XXX.75.188.0 /24 network to go out through MTO and that cla...
