Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a GEC formed by 2 link GE beetwen 2 Cat6500 (link1 and link2), one with IOS Native and the another with Hybrid. In each link there is a monitor device that analize all packets (until L7). The GEC is balancing by default, Souce/Destination IP i...
On Cat6500 with native IOS are appear the following message:%MLS_STAT-SP-4-IP_LEN_ERR: MAC/IP length inconsistencies This messages say that a PC with a bad NIC, bad driver or bad application is sending frame errors.But I need to know any IOS command ...
On Cat6500 with native IOS are appear the following message:%MLS_STAT-SP-4-IP_LEN_ERR: MAC/IP length inconsistencies This messages say that a PC with a bad NIC, bad driver or bad application is sending frame errors.But I need to know any IOS command ...
I´m having problems with ARP traffic. Is possible limit this traffic on a router´s interface with the following command:router (config)#access-list nn permitrouter(config-if)#rate-limit .....How Can I limit this traffic ?regards.
Hi,Is there a risk in the Cat6500's operation with the way to find the source of the problem ?Do you have any document about this ? Before open the case.regards.
I tried with service policy input ratelimitarp, but I see the same behavior. The Ubr7200 is running the 12.2(15)BC1 and the service policy is applied on the cable interface, will be any restriction about kind of the interface that must be apply this ...
Hi,I made the following: class-map match-all arp match protocol arp! policy-map ratelimitarp class arp police cir 8000 bc 1500 be 1500 conform-action transmit exceed-action drop violate-action drop!interface Cable2/0 bandwidth 75000 ip address 2...
Hi thanks for your answer, with the followings example:access-list 200 permit 0x806 0x???rate-limit input access-group 200 8000 1500 2000 conform-action transmit exceed-action transmitCan I get the same result that with class-map ?regards.
Excuseme my insistence, I have some CSSs with the followiing version:4.01 Build 495.00 Build 295.00 Build 695.00 Build 455.02 Build 35.03 Build 15So, these release are afffect, is it right ?
