Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I implemented this using a host name rather than an IP and it is working OK. With the winsock proxy, the only thing I can think of is to make sure that the CW2000 server's IP address (or range) is included in the proxy server's Local Address Table (...
Hello,I use HP NNM to collect this data from the following. For the exact CPU utilization this second, use .1.3.6.1.4.1.9.2.1.56. For utilization over a 5 minute average collect on .1.3.6.1.4.1.9.2.1.58. You can then create a threshold event in Ne...
The MIB you need is CISCO-ENVMON-MIB.my This mib is dependant on the following: CISCO-SMI.my, SNMPv2-SMI.my, SNMPv2-TC.my, and SNMPv2-CONF.my I found all of these at ftp://ftp.cisco.com/pub/mibs/v2 The SNMP version 1 mibs are available under the ...
