Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How can I configure CISCO Router CGR1120 to all node's address is formed by an specific prefix + node's EUI64, as example below: Prefix: fa75:4433:4433:1010/64 Node 1: EUI-64 = 10-23-4f-4a-00-00-10-1e IPv6 = fa75:4433:4433:1010:1023:4f4a:...
I'm confused with your response because I understand that the CGR1120 router is the DHCPv6 server, then the router is the element in the network that will assign an IPv6 to each node. In fact, I would like that the application IPv6 (prefix FDA7:5555:...
I'm developing a tool to test remotely different devices connected to a WAN formed by CISCO CGR1120 router (a WiSUN solution). My tool will not communicate to the router to get the device's address. Then, from the operator's point of view, it's easie...
First of all, thank you for all the collaborations, but it didn't solve my problem. The original configuration was: interface Wpan4/1no ip addressip broadcast-address 0.0.0.0no ip route-cacheieee154 beacon-async min-interval 10 max-interval 20 suppre...
