Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
VLAN questions. I have a fast ethernet with vlans 1, 10, 20, and 30 configured on four sub intervaces. Each switch has an IP within VLAN 1. Everything was reachable via ping. Then, I placed 12 interfaces on one swith into VLAN 10, and lost connectivi...
Hello! I have just configured three cisco routers with OSPF areas 0 and 1. One router in area 0 also has a RIP link to a soho router for WAN access. I have interconnectivity between all three routers through OSPF. I can also reach the soho through th...
Hi,I am having a problem reaching a soho linksys e1000 router through a second hop cisco 2900 router.Here is a brief topology of the network: I am using OSPF area 100 for all networks except for 192.168.2.0 on R1 to E1000 which is RIPv2R1 directly co...
Hi guys, sorry to spam up the boards with the same basic CCNA level stuff, but I have a couple of questions about ios differences, limitations, and references. I have the following three switches. One appears to be considerably dated in regard to sof...
Hi, I am having some difficulty understanding a setback I'm experiencing with RIP version 2 advertising and a loopback design.I have 3 routers, each connected through ethernet and serial, and each with a loopback interface using a /29 mask and the ip...
The router trunk port was inside the range of switchports I was setting to vlan 10. I still have some work to do understanding why my 2500 won't receive VTP updates and counters aren't incrementing, but that's another topic. Thank you for your assist...
I also see that my revision numbers don't match on VTP, and a website offered the following solution/explaination:VTP Status don’t show correct Configuration Revisionby adnan on April 12, 2009If the configuration revision of the client switch is mor...
Ahmed,I suspect some of my issues are stemming from my VTP setup. I am using the following three switches, here are the versions for each:SW1Cisco Internetwork Operating System SoftwareIOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA6, R...
Also:Port Mode Encapsulation Status Native vlanFa0/23 on 802.1q trunking 1Fa0/24 on 802.1q trunking 1Port Vlans allowed on trunkFa0/23 1-4094Fa0/24 1-4094Po...
Thank you Alain, that definitely did the trick. I take the CCNA composite tomorrow and there is no way I could have focused on the fundamentals with that mystery hanging in my brain.
