Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Upgraded a 9400 and the firmware is not updated. There are 2 sups and it should have updated everything on switch. Doing a show module the SW is 17.03.04 but FM is 16.6.2r for all but one mac. The last mac is 17.3.1r for FW (Firmware). Do we need to...
Have a routing issue, trying to setup FTP site in DMZ. The route will work outside via the gateway, but I can't get to the DMZ unless I change the the gateway to the inside FW IP address. So, I try and ping the FTP server and get no reply when Gate...
I am trying to NAT my FTP to the outside. I can't get to that IP. Am I missing something? I have FTP allowed in access rules. For NATstatic NATinside - to the internal IPOutside - external IPI can ping the server from firewall internally. What ...
I have many VLANs setup on one network using a HP switch. I am trying to extend that network to a cisco switch via a fiber connection and then convert to gigabit for cisco. I Have a link light on the cisco but when I add a pc via a static address I...
Hi Leo, The active sup is currently on 16 and standby is 17 firmware. SW is 17 across the board. Anything else we have to do here? Could you briefly explain what is being done with that command ? Much appreciated.
Your topology is correct. I think I may have answered my own question, two nics. With two nics the inside and outside will be able to be accessible. I am going to give that a shot.
