Version:Cisco IOS Software, C2900 Software (C2900-UNIVERSALK9-M), Version 15.4(3)M3, call Flow: IP Phone (SCCP)---Diling out using---T1--> PSTN after one ring call getting Disconnected
i have built a System Call handler for one site, i setup caller in puts and Uploaded greeting and it working fine +++but customer Wanted calls to be transfer to an external number and it should be activate manuallyfor this i created another handler ...
the issue is resolved, there is no issue from the router end, call flow IP Phone(SCCP)--->CME--->T1--->Avaya PBX---> call FWD---another DID Number Call is getting Failed to due to Delay in response after cutting down the Avaya PBX and dialing Direct...
Hi Java, calling party number :8976called party number:17817925555 adding the file debug ccapi inout, not able to run the command debug isdn q931 its not taking
HI Java, I Configured the same as below, but customer is saying its long procedure, asking for some short procedure to do it. For IVR:1)From landline phone dial 800012 2) Enter Greeting admin id 50003 3) PIN:XXXXX 4) Enter call handler number 161XX...