Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have tried two Catalyst 3560 PoE switches on a specific jack. The first switch repeatedly dropped PoE cameras requiring a complete reload to bring back up. I tried a newer model 3560, and the same phenomena occurred. Our electricians just dis...
The only way I can connect anymore is via console. I thought I had left all the SSH config the same except for changing the passwords to secrets. Please help!
I'm trying to use local AAA to set up credentials for console and VTY. After applying the following commands I can no longer log into the switch. It disconnects me after several failed attempts. Can you tell me what I am doing wrong? aaa new-modelaaa...
I have a Cat 5e connection to a GB Netgear switch and it blinks green. When I show the interface it says 100 Mb/s full duplex connection. I ran a Cat 6 connection and now it blinks amber, but the interface still shows 100 Mb/s full duplex connection...
BB, Here is the output I was able to obtain. Sh ip route is not working for some reason. I tried to enable IP routing from config t, but I got an error on the word "routing". SW-2060S-9012SR#sh runBuilding configuration...Current configuration : 1078...
BB, The router is a SOHO Routerboard router, not a Cisco. The PC is connected directly to the switch. I tried a traceroute from the switch to 192.168.0.30, but gave up and cancelled it after 12 hops. The switch pings 192.168.0.30 immediately with no ...
