Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a quick question and I hope it is just to verify. I need to move some traffic to a the high priority queue and it is base on the type of traffic. Here is the ACL I am planning on using using and the calling that ACL in the QoS template.ip acc...
I am having issues with getting out 2811s to failover from the main link to the back up link. I have a Main router with 2 sites connected to it. Both sites have a fiber/ethernet connection a T1/serial link. The fiber is the main link and the T1 is...
I know this is a bit crazy, but I have a situation where I would like to send some traffic with public IP addresses out of a router that needs to be NATTED. Our main Internet connection doesn't need to be as the IP space is routed back to that devic...
Hi All,I am trying to get OSPF to distributed the VPN tunnel routes to my internal router. I can get the both sides to see each other as neighbors, and the ASA sees the routers OSPF routes, but the router is not getting the updated routes from the A...
I have a dilemma. We have a LAN 2 LAN with a remote site and I need somehow NAT their subnet with and address pool on my side so I can route this traffic elsewhere where there is a conflicting network. I have an ASA 5510 on this side and they are r...
It is an Adtran router, the AOS is very similar to an IOS. This setup a while back by someone else and I need to tweak it a bit. The QoS template does work but the was squeezing out traffic for the call center app at our remote sites and it is consid...
OK...we are using #3 so if the interface on both sides goes go down ie either shutdown or upplugged on both ends it fails over. I can do this manually, but it is a pain. I can just telnet to the local router and shutdown the ethernet interface and t...
Static routes...I was told that I needed to enter both routes as a 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx for the router to see it as route to send to. Just that I would need to add a higher metric. The networks that the static routes are in the EIGRP netw...
I got it working. I put in a static route and once I pulled it out it started working. Not sure why it didn't like a static route, but who am I to argue with success. Thanks for the input.
