Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have few cisco 2960 (model : WS-C2960-24TT-L). I am doing vla, port-security. In port-security it only fixed the no of maximum port allowed per port. But I need to fixed the IP address per port; that mean the pre-define ip address can be accesse...
I am using one Cisco 2821 router with built in 2 GB interface. I have add one HWIC 4ESW and it works fine. But when I add another HWIC 4ESW than it is not working. The interface is detected and it show 8 FastEthernet. But when I configure them as swi...
I have the following connectivity.PIX A, PIX B and PIX C is connected to internet. There is a VPN tunnel from PIX A to PIX B and another tunnel from PIX B to PIX C. VPN tunnels are configured and from A-PIX network I can access B-PIX local network. I...
I have a Cisco 2801 router with C2801-IPBASE-M IOS. I have already done a lot of port forward. Now if I want to add more udp port forward it give the following error:Maximum UDP forwarding ports in useIs there any limitation of UDP port forward? Can ...
I am not doing any nat there. We are providing a service for a software which need to be port forward. For each connectivity we need to forward 3 udp port with specific ip helper-address. Now the router is denying to add new portforward.
