Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
This is going to sound crazy but for no reason at all we stopped seeing all administrative links on the wireless Web Gui of our cisco 3650 switch.
The users that login to the switch have privilege level 15 and can perform all administrative ...
Hi All,
After more than a week researching this i am just about ready to throw the box off the window.
In the office we have four zones configured on an ISR-G2 router. Namely the outside, inside, dmz and byod.
I am trying to inspect a set of protoco...
Hi Rasika,
This seems to be related to CSCuy76460 after all. My administrators use special characters which apparently the 3650 has trouble coping with.
I have escalated this to TAC for further investigation but it seems that the web gui likes you t...
Hi Rasika,
Thanks for looking into this.
From a quick look at my config i can confirm that all the commands are in place as you can see from the output bellow
Switch#sh run all | s ip httpip http serverip http port 80ip http authentication localip ht...
Hi All,
We were able to resolve this after all.
It was actually not related to that particular ISR.
In fact the problem was with a core switch in the network that was interefering with the routing to that router.
Thank you Philip for the interest yo...
Hi Philip,
I did try this suggestion but unfortunately there is no change.
I also tried removing the route-map completely again the same behavior persists.