Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 2911 router GI1/0/0 is configure with ISP provided static: 67.254.224.30 255.255.255.248GI1/01 is configured to my internal network: 196.168.2.0 255.255.255.0 and connects to a 2960 switch on GI1/0/1. I also have VLAN1 setup across all the G...
That did it. All my clients came on line almost instanly after entering the command.Wow!! Thank you all so much for your amazing assistance here. I know enough to be dangerous. But 1 litting setting can ruin the whole config.Thanks again.
As it stands now:From an internal client (192.168.2.94)I can access my server via RDP (192.168.2.2)I can ping my router gatewasy (67.254.24.26)I can not ping my ISP final Gateway (67.254.24.25)From my server (192.168.2.2) everything works.I am updati...
Yea, ping to google is no reply.the 45 number was just a bad copy/paste.IP NAT Trans (after I cleared the table).WI-54024-RTR1#sho ip nat translationsPro Inside global Inside local Outside local Outside globaludp 67.254.24.2...
Thanks rwolf, That did not resolve either.Still unable to get client pc to the internet.The updated area looks like this now:ip nat source list 1 interface GigabitEthernet0/0 overloadip nat inside source static 192.168.2.2 45.41.223.226ip route 0.0.0...
