About wavevector

wavevector · 05-01-2016

Hello, I know that there is a way to stack 3750s, but I only have short stacking cables. Is there a way to put the main 3750 on floor 1, and run a cat 6 cable from it to another 3750 on floor 2, and have a computer which is plugged into floor 1, be...

wavevector · 04-11-2016

Hello, I reset the switch using these configurations (sensitive information was changed), yet when I plug in the internet cable to the console port on the back, and plug in the computer on the front with cat 6 cables, the internet does not pass throu...

wavevector · 05-01-2016

Hello, By following all of your suggestions, I have been able to get it to work. Thank you all!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! Walter

wavevector · 04-14-2016

Hello Good Sir, I have tested all the cables, and it works directly from the router, although not from the 3750 switch. I have reset multiple 3750 switches, and all of them seem to have the same issue, while they were all from different parties that...

wavevector · 04-12-2016

Hey, When I plugged in the internet cat 6 cable (came from Arris TG852 modem to cisco rv110w to 3750 switch) to one of the front ethernet ports, and then in ethernet port 2, I put the cat 6 cable from the 3750 to the i7 computer, it would not pass in...

Member Since	‎04-11-2016 12:01 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	5

User Statistics

User Activity

Is there a way to have one 3750 switch on floor one, and another via cat 6 on floor 2, where a printer can still be seen as part of the network?

Question about how to use cisco 3750 switches on a simple brighthouse modem in Orlando Florida

Hello,

Hello Good Sir,

Hey,