Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey everyone, I am studying for my CCNA and I have aquired a 2960 WS-C2960-24TT-L switch (used).I am trying to acces the switch while conected to the console port.Everything loads up, but when I get the "Press RETURN to get started!" I cannot do anyt...
So I found out that the console cable I had was good, but the adapter to USB had something bad with it.Long story short, the adapter was receiving data, not allowing to send data.Bought a new console cable and everything worked. Sorry for all the was...
1. I bought it from someone that used it for his studies as well. 2. I don't think there is a cable issue, if there was, I wouldn't be able to view the console at all. Right?3. settings are good. Is there any chance the console port has been disable ...
I have attached 2 photos, showing my putty setting are good, and the cable I use.I also attached a video of the switch loading. I do not think there is an issue with the serial cable, or else I wouldn't be able to see the switch loading in the cons...
Hi, I have tried Putty and SecureCRT.The settings are fine. Also, when I am using telnet, i can control the switch perfectly fine.It seems the issue is doing so with console cable only, I am clueless.
