Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ACE that I configured a couple of days ago with some very rudimentary configs for load sharing an ldap service. The service worked for one day with no problems. This morning around 9am, it stopped working. I can ping the VIP but cannot teln...
Is there an equivalent of aaa local-override for the ASA? I would like to have local accounts work on my ASA even if the tacacs server is operational.Thanks, gary
I have a problem with Citrix dropping connections when going through the CSS. I am just doing a L3 content and the CAG is handling all the SSL.I have set the flow-timeouts and verified that flows are NOT timing out with a show flows.I have enabled tc...
I'm getting ready to upgrade two CSS's in box-to-box redundancy mode. The upgrade is simple enough, but what are the best practices for two boxes in box-to-box?I suppose I can copy the software up to the master box. Then force the standby box to be m...
How can I configure loadbalance to operate as a failover?I don't really want to loadbalance the real servers. I want one to be the "primary" unless it fails (probe dies) then it will move connections to the other real server.
Thanks rocash, I knew it was something simple I was just overlooking it. That actually was in the config yesterday but another person removed and re-installed the access list that was at the top which removed the global access-group input All statem...
Ok, how can I get the software ftp'd to the secondary without forcing it to be master? In box-to-box the interfaces on the secondary don't work with the exception of the redundancy-protocol interface which is just a cable between the two boxes.Seems ...
Thanks for the reference. From looking at the reference, can't I just build a backup-rserver in the same serverfarm? Seems like I wouldn't need the backup serverfarm. At any rate, thanks very much for the tip. With these commands I can get it working...
