Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The RVS4000 supports 4 active VLANs and has a configuration item to allow routing between VLANs. To accomplish this (routing between VLANS), we would need independent interface IP addresses for each participating VLAN. I haven't found where to conf...
I am trying to set up a PIX501 so that an outside W2K mobile user can IPSEC/L2TP into the "inside". I'm using PSK.It works perfectly without a NAT box in between, but when I have to cross NAT (using NAT-T), phase 2 negotiation fails. I have enabled...
Thanks for the quick reply, tekliu.Do I also define an IP address for each VLAN (interface address) on that page?Can I define the info on the DHCP page without actually using or enabling DHCP (e.g. define a scope with no addresses).I'm assuming, then...
